Product Information Page for S-Tec System 60-2 Autopilot

	PRODUCT
	INFORMATION
	PAGE

System 60-2

FEATURES

Two axis roll and pitch autopilot

System includes seperate programmer/annunciator (shown above), turn coordinator, roll & pitch servos, remote roll & pitch computers, and altitude pressure transducer

Mode selector switches for heading (HDG), navigation (NAV), reverse (REV), vertical speed (VS), and attitude hold functions (ALT)

Trim light and sonalert warn of out-of-trim conditions

UP/DOWN switches used for vertical speed rate, barometric differential correction in altitude hold mode, and out-of-trim indications

Heading mode, VOR/LOC/LOC backcourse intercept and tracking

Glideslope capture and track

Vertical speed command for climb and descent control

VOR/LOC/GS Course Deviation Warning

** CALL FOR INSTALLATION PRICE - OVER THE COUNTER SALES ONLY FOR EXPERIMENTAL AIRCRAFT

*OPTIONS
Flight Director Steering Horizon - Information Directional Gyro or HSI - Information Altitude/Vertical Speed Selector - Information Yaw Damper/Rudder Trim System - Information Automatic Electric Pitch Trim - Information Note: Autotrim is optional on some aircraft models - see STC list for approvals

SPECIFICATIONS

SYSTEM:

Avg. Operating Current:	0.5 amp	Max. Current:	3.0 Amps
TSO:	FAA requirements C-9c

PROGRAMMER/ANNUNCIATOR:

Power Requirements:	14/28 VDC	Weight:	1.9 lbs.
Dimensions:	3.3" x 3.3" x 5.2"

TURN COORDINATOR:

Power Requirements:	14/28 VDC	Flag Voltage Detector:	(operating limits) 9.0 VDC approx.
Flag RPM Detector:	(operating limits) nominal RPM less 10%	Current Requirements:	0.3 Amp
Weight:	1.8 lbs.	Dimensions:	3.28" x 3.28" x 5.62"

ROLL SERVO:

Power Requirements:	14/28 VDC	Current Requirements:	Included in System value power required
Weight:	2.9 lbs.	Dimensions:	3.75" x 3.75" x 7.25"

ROLL COMPUTER:

Power Requirements:	14/28 VDC	Weight:	3.3 lbs.
Dimensions:	5.25" x 2.1" x 13.3"

PITCH COMPUTER:

Power Requirements:	14/28 VDC	Weight:	3.3 lbs.
Dimensions:	5.25" x 2.1" x 13.3"

PITCH SERVO/TRIM SENSOR:

Power Requirements:	14/28 VDC	Current Requirements:	Included in System value power required
Weight:	2.9 lbs.	Dimensions:	3.75" x 3.75" x 7.25"

ALTITUDE PRESSURE TRANSDUCER:

Power Requirements:	10 VDC (supplied by pitch computer	Current Requirements:	Included in System value power required
Weight:	2.9 lbs.	Dimensions:	3.75" x 3.75" x 7.25"

sys60-2