| Weights: |
Display unit: 250 g / Bearing antenna: 2000 g |
| Dimensions: |
Display unit: 82mm W x 82mm H x 43mm D / Bearing antenna: ∅270mm x 185mm |
| Method of bearing: |
Doppler-principle (3kHz rotational frequency, right / left rotation) |
| bearing accuracy: |
±5° |
| Internal resolution: |
1° |
| Sensitivity: |
RF-Voltage at Receiver Input (50Ohms) VHF < 100nV; Sea Band < 100nV; UHF < 100nV; 406MHz < 150nV |
| Frequency stability: |
±2.0 ppm (Δf/f=±2·10-6) [at Temperature range -30°C to +80°C] |
| Receiving channels: |
8 (four of them are free adjustable) |
| Receiving frequencies: |
EMERGENCY MODE: TRAINING MODE: 121.500 MHz (VHF) [118.000 - 122.975] MHz 156.800 MHz (maritime, channel 16) [156.000 - 161.975] MHz 243.000 MHz (UHF) [240.000 - 245.975] MHz 406.025 MHz (Cospas/Sarsat) [400.000 - 409.975] MHz |
| Scanning mode: |
When receiving Cospas/Sarsat signals, the emergency frequencies 121,500 MHz and 243,000 MHz may be monitored simultaneously |
| Cospas/Sarsat analysis: |
Reception and analysis/decoding of Cospas/Sarsat data signal (112 resp. 144 bit, 400 baud, biphase L-phase modulated, with Bose-Chaudhuri-Hocquenghem error test / specified according Cospas/Sarsat C/S T.001 October 1999) |
| Bearable kinds of modulation: |
A3E, F3E, A3X (ELT-modulation); bearing mostly independent of modulation |
| Polarisation: |
Vertical |
| Error of polarisation: |
≤ 5° at 60° field vector rotation |
| Garbling cone: |
app. 30° to the vertical |
| Time of response: |
≤ 50 ms (with sufficient receiving field strength) |
| LC-graphic display: |
128x64 dots, supertwist /transflective, extended range of temperature, dark-blue display on yellow-green background, lit up. Free adjustable (exponentiell) dimming of brightness |
| Supply voltage range: |
12 V - 35 V DC |
| Current consumption: |
LCD-background lighting Off: max. 350 mA (12 V DC) / 200 mA (24 V DC) LCD-background lighting 100%: max. 600 mA (12 V DC) / 300 mA (24 V DC) |
| Interface: |
External connections (optional / at Sub-D 9pol. connector X4 male) |
| Pin 8: |
EXTERNAL VOLTAGE FOR VARIABLE DIMMING: Analog input signal for variable controlling of the LCD-background and legends illumination. Input voltage free adjustable in the range of [1.5-33]V at edit menu (Display Control Unit Page 5). Look chapter edit menu. Default setting [10-28]V. (10V=Off, 28V=max. dimming) Impedance of input > 50 kΩ |
| Pin 6: |
NIGHT STATUS LINE: Low-active. At input voltage < 2.5V the dimming operates in night mode. Max. of brightness ca. 2% of day/default mode impedance of input > 50 kΩ Only at SAR-DF 517 N with NVG front panel, otherwise do not use. |
| Pin 4: |
NVG STATUS LINE: Low-active. At input voltage < 2,5V the dimming operates in NVG mode. Max. of brightness ca. 2% of day/default mode Impedance of input > 50 kΩ Only at SAR-DF 517 N with NVG front panel, otherwise don’t connect. |
| Pin 7: |
AUDIO OUTPUT SIGNAL: AC coupled voltage source with very low inner resistance. Max. output voltage app. 8Vss = 2,83VRMS at Volume Max. Max. output power ca. 2W with 4Ω speaker. If a headphone is connected [32…600]Ω / 100mW, we recommend using a resistor (18Ω / 0,25W) Between audio output and headphone to prevent damaging the headphone. |
| Serial interface RS232: |
(9600 baud, 8 databits, 1 stoppbit, no parity) |
| Pin 3: |
Txd: Serial output (ca. ±10V) |
| Pin 2: |
Rxd: Serial input (ca. ±10V) |
| Display: |
Permissible operating temperature: -20°C - +60°C Permissible storage temperature: -30°C - +80°C |
| Antenna: |
Permissible operating temperature: -40°C - +60°C Permissible storage temperature: -55°C - +80°C |
| Protection System: |
Bearing antenna : IP 67 |